GET A FREE QUOTE

Richmond sits 3 km east of the Melbourne CBD in the City of Yarra, and its housing covers more than a century of building. Wikipedia describes most of its houses as single fronted Victorian style homes built from the 1850s to the 1930s, typically on long thin blocks with two bedrooms at the front and the living room and kitchen at the back. Since the early 1990s the suburb has also gained converted warehouse residences, set among public housing high-rise flats and Victorian-era terraces. The Malthouse, a conversion of former silos into apartments, is the best-known example of that change.
The ABS 2021 Census counts 13,301 occupied private dwellings in Richmond. Of those, 53.0% are flats or apartments, 30.7% are semi-detached, row or terrace houses and townhouses, and only 15.6% are separate houses, against 73.4% across Victoria.
Peak Air Conditioning Richmond is set up around that housing rather than around a large detached house. A single-fronted home puts its bedrooms and its living area at opposite ends of a narrow plan, so one wall unit at one end may not carry heating or cooling to the other, and the choice between a split system for each end, a ducted system or hydronic panels starts with the floor plan. An apartment in a tower or a warehouse conversion raises different questions: where an outdoor unit can sit, how far the pipe run has to travel, and who has to approve it. The full range of heating and cooling services is set out on the homepage.

Every job starts with a measure-up at the property. For a new system the technician records each room's size, the ceiling height, the windows and which sides face the sun. Mitsubishi Electric's buying guide says sizing "isn't as simple as looking at the square meterage of your home" and that "a professional Heat Load Calculation is essential". The measure-up also notes where the outdoor unit can go, the route for the pipes and drain, roof or underfloor access and the state of the switchboard. The findings go into a written quote, which is accepted before any work is booked, and the air conditioning installation page explains how the system itself is chosen.
The second step is booking the right trade for each part of the job. Refrigerant pipework, the indoor and outdoor units and any regas go to an air conditioning technician. A gas ducted heater or a hydronic boiler goes to a gasfitter. A new circuit, an isolator or switchboard work goes to an electrician. A split system install often needs two of these trades, and replacing a gas heater with a reverse cycle system can need all three, so each one is booked for the part of the work it covers.
The last step is a test before leaving. Refrigerant pipework is pressure tested before evacuation, which the Australian Refrigeration Council says "is required for all RAC piping systems". As general commissioning practice, the finished system is then run in cooling and heating, with the airflow and the outlet temperature checked at each indoor unit. A serviced gas appliance is checked against the AS 4575 Appendix E checklist, which includes carbon monoxide testing. Finally the controls are explained and the operating instructions and commissioning data are handed over.


Three trades share the work, and each one stays on its own part of the job.
Air conditioning technicians handle anything that carries refrigerant. That covers split system and multi-head installs, ducted and reverse cycle air conditioning, the pipe runs and condensate drains between the indoor and outdoor units, regas and leak repairs, and routine servicing, where the filters, coil, drain and refrigerant pressures are checked. The air conditioning service page sets out what a full service includes. In a narrow terrace room the technician also plans where the indoor head sits: Mitsubishi Electric's installation manual for its MSZ-AP split systems recommends 1.8 m to 2.3 m from the floor, "where air flow is not blocked".
Heating gasfitters work on the gas side. They install, service and repair gas ducted heating, including a heater unit in the roof space or beneath the floor and its flue, and the gas boilers that heat water for hydronic heating radiator panels. Gas work also includes disconnecting an old gas heater when it is replaced with a reverse cycle system.
Electricians handle the power supply. Melbourne cost guide The Quote Yard lists "dedicated circuits, isolator replacement, switchboard capacity and any wiring alterations" as electrician's work, and Mitsubishi Electric's manual leaves the wiring between the indoor and outdoor units to an electrical contractor too. In an older house, the capacity of the switchboard can decide whether a new system goes in without an upgrade.

Each trade's work is done under the licence that work requires. No licence numbers are listed on this page, so ask the tradesperson who attends to show theirs.
Refrigerant work is done under a refrigerant handling licence from the Australian Refrigeration Council, which runs the ARCtick scheme. ARC states that "any person who handles refrigerant or works on RAC equipment must hold a refrigerant handling licence", and its definition of handling includes installing, commissioning, servicing or maintaining RAC equipment whether or not refrigerant is present. That covers a split system install and a routine service as well as a regas.
Gas work is done by a licensed gasfitter registered with the Building and Plumbing Commission. When a Type A appliance such as a gas ducted heater or a hydronic boiler is installed, relocated or replaced, the BPC says a compliance certificate "must be issued" and given to the customer within five days of completing the work. Gas servicing in Victoria must be carried out in accordance with AS 4575, and the customer receives a copy of the servicing record, including the Appendix E checklist, within 5 days. Better Health Channel suggests checking a gasfitter on the BPC website or "asking to see the tradesperson's BPC licence".
Electrical work is done by a licensed electrician, who issues a Certificate of Electrical Safety. Energy Safe Victoria says the certificate "is required by the Electricity Safety Act 1998" and that a copy goes to the customer. For non-prescribed work, which ESV defines as all other electrical installation work, the copy is due within 30 days. Prescribed work must also be inspected by a licensed electrical inspector, and its copy is due within 4 days.


What a buyer gets from Peak Air Conditioning Richmond depends on the property.
A terrace owner gets a plan built around the long, narrow layout: whether a split system in the front bedrooms and another in the rear living area suits the house better than one ducted system, and whether the roof space or the subfloor has room for ductwork and pipes. The measure-up settles that before the quote, not after the units arrive.
An apartment owner gets the outdoor unit question dealt with early. Under the Consumer Affairs Victoria model rules for owners corporations, an owner must obtain written approval before changing the external appearance of a lot, so a balcony or wall-mounted outdoor unit may need approval before installation day. The split system installation page covers where outdoor units can go.
A landlord, property manager or renter gets a booking that works for everyone who has to be there. In Richmond 54.7% of occupied homes are rented (ABS 2021 Census). Consumer Affairs Victoria requires rental providers to have a gas safety check and an electrical safety check done every 2 years, and every rental must have a fixed heater in good working order in the main living area; landlords should check the current CAV rules for their own agreement. Calls are taken from 6am to 10pm, seven days, and same-day visits are arranged where possible.
The same approach applies across the 12 suburbs covered, from neighbouring Cremorne to Fitzroy and Carlton in the inner north and Prahran and Windsor to the south.
GET A FREE QUOTE
BUSINESS
SERVICES
OPERATING HOURS
Sun: 6:00am - 10:00pm
Mon: 6:00am - 10:00pm
Tue: 6:00am - 10:00pm
Wed: 6:00am - 10:00pm
Thu: 6:00am - 10:00pm
Fri: 6:00am - 10:00pm
Sat: 6:00am - 10:00pm